Ibm-partner-pavilion PROJECTOR E400 Manuel d'utilisateur Page 1

IBM E400 PROJECTO R User’s Gui d e 

Extension cords and related devices Ensure that extension cords, surge protectors, uninterruptible power supplies, and power strips that you use are r

shorten the life of the battery and can also pose a safety hazard. Do not let rechargeable Lithium-Ion batteries completely discharge or store these b

x IBM E400 PROJECTOR: User’s Guide

Registering your option Thank you for purchasing this IBM® product. Please take a few moments to register your product and provide us with information

xii IBM E400 PROJECTOR: User’s Guide

Preface The IBM® E400 projector can be used for both business presentations and home entertainment and is easy to connect, use, and maintain. In addit

If any of the items listed above are missing or damaged, contact your place of purchase. Note: Be sure to retain your proof of purchase; it will be r

Chapter 1. Introduction The figures below show the features of the projector. 1 Lens/focus 2 IR receiver 3 Connectors 4 Power cord connector

1 Zoom 2 Focus 3 Power 4 System status LEDs 5 Control buttons 6 Source button 7 Menu button 8 Auto button 9 Speaker Figure 1-2. T

Figure 1-3. Top view of the control buttons and LEDs on the projector 1 Power (LED) 2 Ready (LED) 3 Keystone/Up cursor 4 Volume/ Right cursor

1 Projection lamp cover 2 Elevator foot 3 Leveling foot 4 Ceiling support holes Figure 1-5. Bottom view of the projector 1-4 IBM E400 PROJE

Chapter 2. Setting up the projector This chapter provides information on starting and shutting down the projector, adjusting the projector height and

8. When the ″Power off?/Press Power again″ message appears, press the Power button. The projector turns off.Note: Leave the power cable plugged in

v Position the projector within 2.7 m (9 ft) of your power source and within 1.8 m (6 ft) of your video device (unless you purchase extension cables

2. Use the Image-zoom control on the projector to resize the projected image and screen size as shown in 2. 3. Use the Keystone buttons (sho

Chapter 3. Connecting devices to the projector This chapter provides information on connecting devices to the E400 projector. Connecting devices Compu

3-2 IBM E400 PROJECTOR: User’s Guide

Chapter 4. Using the projector features This chapter provides information on using the remote control, audio, keypad buttons, and other projector feat

Inserting the remote control batteries When using the remote control for the first time, install the batteries that were supplied. Follow the steps be

Operating range The remote control uses infrared transmission to control the projector. It is not necessary to point the remote directly at the projec

IBM E400 PROJECTO R User’s Gui d e 

4-4 IBM E400 PROJECTOR: User’s Guide

Chapter 5. On-Screen Display menu controls This projector has an On-Screen Display that lets you make image adjustments and change various settings. N

2. Press the cursor left/right button to move to the Quality menu. 3. Press the cursor up/down button to move up and down in the Quality menu.

Item Description Default Color Tint Press the cursor left/right button to adjust the video tint/hue. Color tint is only active when the input source i

Properties menu Follow the steps below to access the Properties menu. 1. Press the Menu button to open the OSD menu. 2. Press the cursor left/righ

Options menu To access the Options menu, follow the steps below. 1. Press the Menu button to open the OSD menu. 2. Press the cursor left/right but

Item Description Default Menu Position Press the cursor left/right button to position the OSD on screen. Range: Left, Right, Center, Down, Up Center M

Item Description Default Video Type Press the cursor left/right button to select the video standard. Video Type is only active when the input source i

Information menu Follow the steps below to access the Information menu. 1. Press the Menu button to open the OSD menu. 2. Press the cursor left/ri

Appendix A. Maintenance This chapter provides information on projector maintenance. Cleaning the lens To clean the lens, complete the following proced

Note: Before using this information and the product it supports, read the information in Appendix D, “Service and Support,” on page D-1 and Appendix E

3. Remove the two screws from the lamp module as shown. 4. Lift the module handle up as shown. 5. Pull firmly on the module handle to remove

Attention: This product contains a Metal Arc Lamp, which contains Mercury. Dispose of it as required by local ordinances and regulations. The USA res

A-4 IBM E400 PROJECTOR: User’s Guide

Appendix B. Troubleshooting The following table provides troubleshooting information for the projector. In some cases, more than one possible solution

Table B-1. Troubleshooting (continued) Problem Solution The lamp goes off. v Power surges can cause the lamp to turn off. Press the Power button twi

Table B-3. Power LED error messages (continued) Power LED number of flashes Explanation 6 Fan error. Refer to Lamp-ready LED to determine which fan. 7

B-4 IBM E400 PROJECTOR: User’s Guide

Appendix C. Specifications Following are specifications for the IBM E400 projector. Temperature (operating) (non-operating) 5° to 35° C (41° to 95° F

C-2 IBM E400 PROJECTOR: User’s Guide

Appendix D. Service and Support The following information describes the technical support that is available for your product, during the warranty peri

Contents Safety information . . . . . . . . . .v General safety information . . . . . . vii Service . . . . . . . . . . . . . . . . vii Power cords

Country or Region Telephone Number Country or Region Telephone Number Belgium Dutch 02-210-9820 French 02-210-9800 New Zealand 0800-446-149 Bolivia 08

Appendix E. IBM Statement of Limited Warranty - Z125-4753-07 - 11/2002 Part 1 - General Terms This Statement of Limited Warranty includes Part 1 - Gen

v any non-IBM products, including those that IBM may procure and provide with or integrate into an IBM Machine at your request.The warranty is void

functionally equivalent to the item replaced. The replacement assumes the warranty service status of the replaced item. Your Additional Responsibiliti

This limit also applies to IBM’s suppliers and your reseller. It is the maximum for which IBM, its suppliers, and your reseller are collectively respo

In accordance with Article 1328 of the Peruvian Civil Code the limitations and exclusions specified in this section will not apply to damages caused b

Arbitration: The following is added under this heading: Disputes arising out of or in connection with this Statement of Limited Warranty shall be fina

If one of the parties refuses or otherwise fails to appoint an arbitrator within 30 days of the date the other party appoints its, the first appointed

arbitration award shall be final and binding for the parties without appeal and shall be in writing and set forth the findings of fact and the conclus

Add the following paragraph in Western Europe (Austria, Belgium, Cyprus, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Liechtens

iv IBM E400 PROJECTOR: User’s Guide

nullity of the execution of this Statement of Limited Warranty shall be settled by Arbitration Court of Moscow; 6) in South Africa, Namibia, Lesotho a

Spango Valley Greenock Scotland PA 16 OAH AUSTRIA, DENMARK, FINLAND, GREECE, ITALY, NETHERLANDS, PORTUGAL, SPAIN, SWEDEN AND SWITZERLAND Limitation of

CONSEQUENCE OF THE EVENT THAT GENERATED THE DAMAGES; OR 4) LOSS OF BUSINESS, REVENUE, GOODWILL, OR ANTICIPATED SAVINGS. THE FOLLOWING TERMS APPLY TO T

GERMANY What this Warranty Covers: The following replaces the first sentence of the first paragraph of this section: The warranty for an IBM Machine c

For the purposes of this section, a ″Default″ means any act, statement, omission, or negligence on the part of IBM in connection with, or in relation

liable to you, whether in contract or tort. A number of Defaults which together result in, or contribute to, substantially the same loss or damage wil

E400 PROJECTOR LAMP Country or Region of Purchase Warranty Period Type of Warranty Service Worldwide 3 months 1, 4 A warranty period of 3 years on

You will deliver or mail as IBM specifies (prepaid unless IBM specifies otherwise) the failing Machine suitably packaged to a location IBM designates.

Country or Region Telephone Number Country or Region Telephone Number Japan Consumer customers 0120-887-870 Business customers 0120-887-874 Venezuela

Appendix F. Notices IBM may not offer the products, services, or features discussed in this document in all countries. Consult your local IBM represen

Safety information Before installing this product, read the Safety Information. Antes de instalar este produto, leia as Informações de Segurança.

vary significantly. Some measurements may have been made on development-level systems and there is no guarantee that these measurements will be the sa

International Business Machines Corporation New Orchard Road Armonk, NY 10504 Telephone: 1-919-543-2193Tested To ComplyWith FCC StandardsFOR

IBM can not accept responsibility for any failure to satisfy the protection requirements resulting from a non-recommended modification of the product,

al fine di fornire ragionevole protezione da interferenze mediante dispositivi di comunicazione in concessione in ambienti residenziali tipici.

F-6 IBM E400 PROJECTOR: User’s Guide

Part Number: 73P2776 Printed in USA (1P) P/N: 73P2776

Läs säkerhetsinformationen innan du installerar den här produkten. vi IBM E400 PROJECTOR: User’s Guide

General safety information Always observe the following precautions to reduce the risk of injury and property damage. Service Do not attempt to servic